Aqara Bewegungsmelder

1. Go to Settings → Devices & services → Add integration and search for Aqara.
2. Follow the config flow – devices on the same network are usually discovered automatically.

1. Open Zigbee2MQTT → Settings → Permit join (or enable joining for a specific coordinator/router).
2. Put Aqara Bewegungsmelder into pairing mode: Reset-Taste 5 Sekunden halten, bis die LED dreimal blinkt.
3. Watch the Zigbee2MQTT log – the device shows up with the model ID lumi.sensor_motion.aq2.
4. Rename the device to a friendly name; entities are exposed to MQTT/Home Assistant automatically.

Supported since Zigbee2MQTT 1.5.0.

1. In Home Assistant go to Settings → Devices & services → ZHA → Add device.
2. Put Aqara Bewegungsmelder into pairing mode: Reset-Taste 5 Sekunden halten, bis die LED dreimal blinkt.
3. Wait for the interview to finish – the device appears as lumi.sensor_motion.aq2.
4. If entities are missing, a ZHA quirk may be required (available from HA ).

1. Open Phoscon → Devices → Add new device and choose the matching category.
2. Put Aqara Bewegungsmelder into pairing mode: Reset-Taste 5 Sekunden halten, bis die LED dreimal blinkt.
3. The device is added as lumi.sensor_motion.aq2 and exposed through the deCONZ REST API.

1. Install and open the matching adapter instance (Zigbee, Z-Wave, Matter, BLE …).
2. Start the pairing mode of the adapter and put Aqara Bewegungsmelder into pairing mode: Reset-Taste 5 Sekunden halten, bis die LED dreimal blinkt.
3. The states show up under iobroker.0.<device>.

1. Install the app of the manufacturer from the Homey App Store.
2. Add the device via Devices → + → Aqara.
3. Put Aqara Bewegungsmelder into pairing mode: Reset-Taste 5 Sekunden halten, bis die LED dreimal blinkt.

1. Open Devices → Add device → Zigbee/Z-Wave and start the discovery.
2. Put Aqara Bewegungsmelder into pairing mode: Reset-Taste 5 Sekunden halten, bis die LED dreimal blinkt.
3. Assign the matching built-in or community driver and click Configure.