Back to all devices

Aqara UT-A01E in Home Assistant

Thermostats & TRV · Zigbee · Floor heating thermostat W500

Zigbee2MQTT Quirk proposed, not merged yet 1 open report

Zigbee device – see the note above on what ZHA needs for it.

Brand: Aqara
Model: UT-A01E
Device type: Thermostats & TRV
Radio: Zigbee
Power: Mains powered
Reports itself as: lumi.airrtc.aeu001
Zigbee2MQTT: Device page on zigbee2mqtt.io

How the device gets into Home Assistant

official ZHA – with a Zigbee coordinator and the ZHA integration; for all its functions it needs a custom quirk, see above. Integration
official Aqara hub – paired with an Aqara hub that works as a Matter bridge (such as the M3 or M2), which shares supported devices with Home Assistant. Integration
add-on Zigbee2MQTT – Zigbee2MQTT runs as an add-on and passes the device on to Home Assistant over MQTT. Integration · Source

Known problems and fixes

Requests for ZHA support

support requested Someone asked ZHA to support this device or one of its functions. since October 19, 2025 · zha-device-handlers #4412

Changes proposed for ZHA

pull request A change to ZHA for this device has been proposed and is waiting for review. since June 7, 2026 · zha-device-handlers #5064

ZHA quirks for this device

Quirk proposed, not merged yet Recommended quirk

Proposed to ZHA and waiting for review – the maintainers check it before it becomes part of Home Assistant.

Adds: Preset State Temperature sensor source NTC sensor type Open window detection Child lock Hysteresis

Source: zha-device-handlers · pull request #5064 · by @jelmer · June 7, 2026
Signature: LUMI / lumi.airrtc.aeu001

2 more quirks for this device

Quirk proposed, not merged yet Aqara / lumi.airrtc.aeu001 zha-device-handlers · pull request #5064 · by @jelmer · June 7, 2026
Custom quirk shared in an issue Aqara / lumi.airrtc.aeu001 zha-device-handlers · issue #4412 · by @soosp · October 26, 2025 · 2 approvals

The quirk is not part of ZHA yet. You can use it as a custom quirk until it is:

Tell ZHA where custom quirks are kept – in configuration.yaml:
```
zha:
  custom_quirks_path: /config/custom_zha_quirks/
```
Create that folder and save the quirk as a .py file in it.
Restart Home Assistant. If the device was paired before, reconfigure it or remove and pair it again so the quirk is applied.
Check it worked: the device page shows the quirk under Zigbee info.

A custom quirk has not been reviewed by the ZHA maintainers. Delete the file once the quirk is part of a Home Assistant release – otherwise the old copy takes precedence.

All quirks in the ZHA quirk database →